Analysis is available through the on-board DRAGEN Bio-IT Platform or on the cloud using BaseSpace Sequence Hub. The following DRAGEN pipelines are available:
The options are based on the available DRAGEN pipelines:
The NextSeq 2000 flow cell can generate up to 120 Gb per sequencing run. For detailed performance parameters, see Specifications for the NextSeq 1000 and NextSeq 2000 Systems.
Run duration depends on the type of flow cell and number of cycles. For example run times, see Specifications for the NextSeq 1000 and NextSeq 2000 Systems.
For each read, entering a minimum of 26 cycles and a maximum of 151 cycles helps ensure data quality. The exact number of cycles depends on your experiment. NextSeq 1000/2000 Control Software requires at least 1 cycle for Read 1, but displays a warning when the number of cycles in Read 1 is less than 26. The total number of cycles for Read 1, Index 1, Index 2, and Read 2 cannot be greater than the number of cycles supported by the kit plus 27. NextSeq 1000/2000 Control Software will display a warning when Index 1 and Index 2 are less than 6 cycles. The warning will not be shown if Index 1 or Index 2 is 0 cycles.
The following applications are targeted for the NextSeq 2000 system:
The loading volume is 20 µl and the loading concentration varies by library type:
Loading Concentration (pM)
AmpliSeq™ for Illumina Library PLUS
Illumina DNA Prep
|Illumina DNA Prep with Enrichment|| |
|100 % PhiX|| |
|TruSeq DNA Nano 350|| |
|TruSeq DNA Nano 550|| |
|TruSeq Stranded mRNA|| |
For other library types, 650 pM is the recommended starting loading concentration. Optimize this concentration over subsequent runs to identify a loading concentration that consistently yields data that meets specifications.
The number of libraries you can sequence at one time depends on the desired coverage. Using supported Illumina kits, you can multiplex up to 384 libraries. For coverage considerations, see the Sequencing Coverage Calculator.
Yes, NextSeq 1000/2000 P2 Reagents include all consumables to support both single-read and paired-end sequencing. During run setup, you can configure the run to generate either single-read or paired-end data.
Custom primers are not currently supported on the NextSeq 2000 System.